News

In most fabrication shops, consumables cost comprises the main part of the production cost. In many shops, consumables are replaced before every shift irrespective of whether they require replacement or not. The consumable cost can be reduced to a very large extent by following proper inspection methods and preventative maintenance of the parts. Electrode Wear...

Plasma cutting is an exact science and paying attention to detail right and paying close attention to the preparation and setting up of the cutting process can go a long way in preventing a lot of problems you may encounter later on during the production process. Here are a few tips and tricks that can...

There are many ways by which the cut quality on the metal can be improved. Here are some tips by which you can improve the appearance of the cut and some of the factors that must be considered are: Is the arc cutting in the correct direction? You can get the squarest cuts on the...

Cut quality is the key point of concern when it comes to plasma cutting and if you’re facing any problems with the cut quality, a few steps of troubleshooting such as adjusting the power levels, adjusting the cut height and speed, using the correct consumables, etc. can help to resolve any problem related to the...

An experienced plasma operator with a well-maintained plasma cutting system can save your business several hours of downtime and money in terms of operating expenses. These savings can result in more profits for your business. However, the key to a successful operation is to avoid the common plasma cutting mistakes that occur often. Over-Using Consumables...

As a fabricator running a cutting operation, if you find that your plasma cutting is not yielding squared edges, it means that your plasma cutting system needs fine-tuning and, in this article, we will discuss how to adjust your plasma equipment’s operation. When you are operating the plasma cutter, not only should you look for...